Scansonic L14 Floorstanding Speakers

Scansonic L14 floorstanding speakers are a passive 2.5-way stereo pair designed for music and the front channels of a home cinema system. Each speaker contains two 6.5-inch woofers and one approximately 25 mm tweeter.

The specified 38 Hz-20 kHz frequency response covers the low-frequency region and the full conventional listening range. With 90 dB sensitivity, the speakers can be paired with a broad selection of suitably powered amplifiers.

Drivers and cabinet construction

The two woofers use multilayer paper cones. This material is selected to balance cone rigidity and damping for the driver size.

The silk-dome tweeter uses a neodymium magnet. A second-order crossover distributes the signal at 1 kHz and 2.5 kHz.

The rigidly braced cabinet has thickened walls to reduce unwanted resonances. Because the bass-reflex ports are located at the rear, the space behind each speaker affects bass balance.

Connecting an amplifier

These are passive speakers, so they require an external stereo amplifier or suitable AV receiver. Connect them with speaker cables, maintaining the same polarity for both channels so the left and right speakers operate in phase.

The recommended amplifier rating is 50-200 W. This range helps identify an appropriate amplifier power class; it does not indicate a continuous listening level.

Nominal impedance is 8 ohms, with a specified minimum of 4 ohms. Choose electronics that can remain stable with this load.

Positioning in the listening room

The 210 mm cabinet width occupies relatively little floor space. Allow for a height of 1000 mm and a depth of 295 mm. These measurements apply to each speaker.

Choose the installation position before moving the speakers, as each one weighs 19.6 kg. Place them on a firm, level surface.

Do not push the cabinets against the wall because the bass-reflex ports face backwards. Begin with open space behind them, then assess the bass from your listening position. If it becomes too prominent, move the speakers farther from the wall in small steps.

Position both speakers at similar distances from the rear and side walls to provide comparable conditions for both stereo channels. Adjust toe-in gradually while listening for a stable central image.

Finishes and home cinema use

Black, white and walnut finishes are available. The package contains a pair of L14 speakers, allowing you to create left and right stereo channels.

In a home cinema system, the pair can serve as the front left and right channels. Select the AV receiver according to the speakers’ impedance and recommended amplifier range. Centre, surround and subwoofer speakers must be chosen separately.

Technical specifications

FAQ

Do these speakers need a separate amplifier?

Yes. This is a passive model without built-in amplification. It requires an external stereo amplifier or an AV receiver capable of handling the specified load.

Which amplifier should I choose?

Choose a 50-200 W amplifier suitable for an 8-ohm nominal impedance. It must also operate stably when the load falls to the specified 4-ohm minimum.

How do I connect the speakers?

Use speaker cables and maintain identical polarity on both channels. This is important for correct stereo phase and a properly centred sound image.

How much space should I leave behind the cabinets?

The exact distance depends on room acoustics. Leave open space for the rear ports and adjust the distance while listening to the bass balance.

Can these speakers be used in a home cinema system?

Yes. The pair is suitable for the front left and right channels. The remaining speakers and an appropriate AV receiver must be selected separately.

What does the 2.5-way design mean?

Both woofers operate in the lower range, but higher frequencies are distributed to them differently. Two crossover frequencies control the signal division.