Pioneer DEH-S120UBG Car CD Receiver
99,00 €
Pioneer DEH-S120UBG is a car CD receiver for drivers who listen to FM radio, CDs, and external music sources. It accepts audio from a USB device, an AUX source, or a compatible Android phone. Android playback requires Android 5.0-7.1.2 and AOA 2.0 support. The built-in MOSFET amplifier serves four channels, while the RCA line output allows compatible external equipment to be connected.
Pioneer DEH-S120UBG car CD receiver is designed for listening to music in your car. It receives FM radio stations and plays CDs. You can also listen to music from a USB device, an AUX source, or a compatible Android phone.
Choice of music sources
FM radio lets you listen to radio stations without connecting a separate music device. The CD player is suitable for an existing compact disc collection. Supported disc formats and recording types are not specified.
Choose the USB connection for music stored on a compatible USB device. The AUX input accepts an analog audio signal from a source connected with a suitable cable. This is practical when your player does not offer a supported USB connection.
Select the connection that best suits your system and the source you use most often. FM works without an external music device, while CD mode requires a physical disc. Use USB for files stored on a compatible USB device and AUX for equipment with an analog audio output. If your system includes an external amplifier, the receiver can send it a signal through the RCA line output. Plan the amplifier, speakers, and power wiring as a separate part of the audio system.
Connecting an Android phone
Music can be played from a compatible Android phone. The phone must run Android 5.0-7.1.2 and support AOA 2.0 (Android Open Accessory 2.0). Compatibility with newer Android versions is not established, so this function is best suited to older phones.
Amplifier and external equipment
The built-in MOSFET amplifier is rated at 50 W × 4. This figure is not defined as continuous RMS power and should not be compared directly with amplifiers rated under stated RMS measurement conditions.
One RCA line output, also known as an RCA pre-out, sends a signal to compatible external equipment and may be used with a suitable external amplifier. It is not a confirmed direct connection for a passive speaker or passive subwoofer.
Initial setup and installation position
Begin listening at a low volume. First select FM, CD, USB, AUX, or a compatible phone, then start playback and raise the volume gradually. Before switching to AUX, lower the volume again. Set the connected source to a moderate level and make the final adjustment on the receiver. If the signal is too quiet or too loud, adjust both levels in small steps to make volume changes between sources less noticeable.
After connecting an external amplifier, make its initial adjustments according to that device manufacturer’s instructions. Increase the receiver volume gradually and mute the system before changing connections. Do not use the RCA output as a power connection for a passive speaker.
The receiver is intended for installation in a car dashboard. Before fitting it, check that the opening, wiring, and available space behind the dashboard are suitable for your vehicle, as exact installation dimensions are not provided. Keep the disc slot and connections easy to reach. Position the control panel where it remains visible and accessible from the normal driving position. Route and secure USB and AUX cables so they cannot interfere with the gear lever, handbrake, or vehicle controls.
Technical specifications
| Model | Pioneer DEH-S120UBG |
|---|---|
| Device type | Car CD receiver |
| Radio | FM |
| Disc playback | CD |
| External music sources | USB devices and compatible Android phones |
| Android compatibility | Android 5.0-7.1.2 with AOA 2.0 support |
| Analog input | AUX |
| Built-in amplifier | MOSFET, 50 W × 4; measurement basis not specified |
| Line output | 1 RCA output for compatible external equipment |
FAQ
Can I connect a new Android phone?
Compatibility is specified only for phones running Android 5.0-7.1.2 and supporting AOA 2.0. Support for current Android versions is not established.
When should I use USB instead of the AUX input?
Choose USB for a compatible USB device. AUX is suitable for a source with an analog audio output connected using an appropriate cable.
Can the RCA output drive a passive speaker directly?
No. The RCA output carries a line-level signal. A passive speaker or passive subwoofer requires a suitable amplifier.
Is 50 W × 4 a continuous RMS rating?
Neither an RMS designation nor measurement conditions are provided. Treat this figure as the stated power rating of the built-in amplifier.
What should I plan before installation?
Allow convenient access to the disc slot and the connections you intend to use. Cables from connected devices must not obstruct any vehicle controls.
